GUI – would you like to save as rounding discharge curve

[Andrew Brown]

Hello everyone,

I have encountered this interesting little bug. When I input a S-Q curve for a reservoir with values accurate to 0.001 m3/s it will work if I hit save in the Graphical editor and then close it and click “no” to “save changes”. However if I hit yes the resulting catchment file will have my S-Q curve in it however it will round all the Q values to the nearest 0.01 m3/s.

Pretty simple work around, just hit save and then select no when the would you like to save pop up comes up when closing the GE but it is a bit annoying.

Here’s a S-Q curve RORB rounded for me:
1, .000, 22, Storage-discharge table (2 values x 22 lines)
0.000, 0.000,
330.150, 0.280,
668.750, 0.280,
1015.890, 0.290,
1371.630, 0.290,
1736.060, 0.290,
2109.240, 0.290,
2491.250, 0.290,
2882.170, 0.290,
3282.060, 0.290,
3691.010, 0.290,
4109.090, 0.290,
4536.370, 0.290,
4972.920, 0.300,
5418.830, 0.300,
5874.160, 0.300,
6338.990, 0.300,
6813.400, 0.300,
7297.450, 0.300,
7791.230, 0.300,
8294.800, 0.300,
50000.000, 0.300,

kind regards,

Andrew

[Benson Liu]

Hi Andrew,

That is a very interesting bug, thank you for posting this. I will make sure it is fixed for the next release.

Kind regards,

Benson

[Andrew Brown]

Hi Benson,

thanks for the reply. It also appears to round the Q values when you use the file->open in the GE.

When is the next release expected to come out?

kind regards,

Andrew

[Benson Liu]

Hi Andrew,

I do not know when the next release will be. There are not any plans currently for a new release but this may change in the future depending on when enhancements are done.

Kind regards,

Benson

[Author]

Posts