(03) 9908 2160
enquiries@harc.com.au

Home Forums Bug reports Minor bug when deselecting ‘Use regional losses’ – and workaround

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #979

    FCRDSru
    Participant

    When using a Data Hub file without regional losses (perhaps because they are missing from the Data Hub), RORB gives an appropriate error message; “Error reading the losses from the file….” and greys out the OK button in the Design Rainfall Specification (ARR2016) dialogue.

    If I click OK and then uncheck the “Use regional losses” check box, I was expecting the OK button to be enabled. It isn’t.

    The workaround is to click Cancel and then run the model again. Then uncheck “Use regional losses” before clicking ok.

    #980

    DavidStephens
    Moderator

    Thanks Tony. We’ll note this one down and address it as part of the next release.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.